Download Sharp LC-60LE835X Specifications
Transcript
Basic adjustment Power save settings ECO No signal off Go to “HOME” > “TV Menu” > “Setup” > “ECO”. Menu CH list :Enter Setup :Exit When set to “Enable”, the TV will automatically enter standby mode if there is no signal input for 15 minutes. NOTE • Even if a TV programme finishes, this function may not operate because of interference from other TV stations or other signals. ECO ECO ECO picture control [On] No operation off Energy save [Off] No signal off [Disable] No operation off [Disable] You can set the TV to automatically power off when no TV operation is performed for 30 minutes or 3 hours. NOTE • “Disable” is the factory preset value. NOTE ECO • You can also select “ECO” by pressing ECO. Sleep timer ECO ECO picture control This function automatically detects the image source and decreases the power consumption while keeping the brightness of the image unchanged. NOTE • This function does not work when “AV mode” is set to “DYNAMIC (Fixed)”, “DYNAMIC” or “AUTO”. • This function does not work when “Energy save” is set to “Standard” or “Advanced”. • This function is greyed out in 3D mode. Allows you to set a time when the TV automatically enters standby mode. You can set the time span for entering standby mode after selecting “Change”. NOTE • Select “Off” to cancel the sleep timer. • When the time has been set, countdown automatically starts. • Five minutes before the preset of time expires, the remaining time displays each minute. ECO Audio only ECO Energy save This function enables you to reduce the backlight brightness in order to decrease the power consumption and increase the backlight life span as shown in the following table. Item Standard Reduces the backlight brightness. Advanced Reduces the backlight brightness more than “Standard”. Off When listening to music from a music programme, you can set the TV off and enjoy audio only. Item On Audio is output without a screen image. Off Both screen images and audio are output. NOTE • When you make operations that change the picture on the TV such as by changing the input source, the “Audio only” function is set to “Off”. The backlight brightness is the same value of your settings in the selected “AV mode”. When “Energy save” is set to “Standard” or “Advanced”, “Energy save” status icons appear in the “Picture” menu and channel information windows. NOTE • This function does not work when “AV mode” is set to “DYNAMIC (Fixed)”. • This function does not work when “3D brightness boost” is set to “High” or “Low”. 35 LC40LE835_book.indb 35 10/7/2011 12:04:45 PM