Download Zebra Z6Mplus User guide
Transcript
124 Troubleshooting Miscellaneous Printer Problems Table 16 • Miscellaneous Printer Problems (Continued) Problem Possible Cause Recommended Solution The printer fails to calibrate or detect the top of the label. The printer was not calibrated for the label being used. Perform the calibration procedure in Calibrate Media and Ribbon Sensor Sensitivity on page 84. The printer is configured for continuous media. Set the media type to noncontinuous media. See Set Media Type on page 75. The driver or software configuration is not set correctly. Driver or software settings produce ZPL commands that can overwrite the printer configuration. Check the driver or software media-related setting. Non-continuous labels are being treated as continuous labels. The printer is configured for continuous media. Set the media type to noncontinuous media. See Set Media Type on page 75. The printer was not calibrated for the media being used. Perform the calibration procedure in Calibrate Media and Ribbon Sensor Sensitivity on page 84. All lights are on, but nothing displays on the LCD, and the printer locks up. Internal electronic or firmware failure. Call a service technician. The printer locks up while running the Power-On Self Test. Main logic board failure. Call a service technician. 13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06