Download OPERATING INSTRUCTIONS

Transcript
Troubleshooting
Failure Message on
Display
TMS 1
The converter measures a
heating current of less than
300 mA when heater is on.
Possible Cause
Measures
Fuse TMS blown.
Step 1: Check fuse
Replace fuse TMS (F4A, 5x20 mm) if blown.
Step 2: Check pump (heating element X31)
Check if the connector of the heating element is connected.
The resistance of the heating element X31 is typically
between 70 Ω and 75 Ω. In case abnormal values are
measured contact Leybold service.
Step 3: Check TMS cable
If step 2 was successful do the following:
Check TMS cable for bent pins
Measure resistance between pins X21/AA and X21/q
with the cable connected to the pump. The resistance
is typically between 70 Ω and 75 Ω.
Replace the cable if it is damaged or in case the measurement of the resistance shows abnormal values now.
Contact Leybold service.
Heating element or internal
pump connection damaged.
TMS/DRIVE cable or connectors damaged.
Converter failure.
TMS 2
The converter measures a
heating current of more than
4 A.
Overvoltage.
Heating element defective.
TMS 3
TMS temperature sensor
reads a temperature higher
than 139 °C.
TMS sensor damaged.
Converter failure.
Converter failure.
TMS 4
TMS temperature sensor
reads a temperature lower
than 1 °C.
TMS sensor short-circuited.
Converter failure.
Check the line voltage (200-240 V +10% / -15%).
Repeat step 2of failure TMS 1. In case the measured
value is less than 60 Ω contact Leybold service.
Contact Leybold service.
Check TMS sensor
Measure the resistance between pins 1 and 3 of the
TMS temperature sensor. The resistance is typically between 110 Ω and 150 Ω (20 °C to 140 °C). Contact
Leybold if the sensor is defective.
Contact Leybold service.
Measure the resistance between pins 1 and 3 of the
TMS temperature sensor. Contact Leybold if the resistance of the sensor is under 100 Ω.
Contact Leybold service.
GA05141_0702 - 09/2004
101