Download Operating Instructions
Transcript
Welcome to the new breed of print processors ... The Nova System is a practical method of producing hand finished quality prints. Our range is designed to meet the needs of the process and make printing a pleasure not a chore. To enable you 10 oblain the best results from your new equipment, it is important that you read the instructions carefully before you proceed. REMEMBER All modern photographic materials are capable of excellent results. Changing from one manufacturer to another will not correct any problems relating to variables in technique or equipment. The only route to constant quality printing is to reduce these variables to a minimum. Small fluctuations in voltage, timing or temperature can cause large changes in image density and colour balance. Producing Colour prints can be as easy as Black and White providing you are in full control of every component. The following steps will assist you: 1) 2) 3) 4) Fit a voltage stabiliser to the enlarger. Time the exposure and process sequence accurately. Temperature control will be handled by your Nova Processor. Use one type of film, paper and chemicals until you are confident enough to experiment. With all Nova Processors it is important to begin by placing your new processor on a table/bench as near to your enlarger as possible, ensuring that the drain taps are easily accessible. 2 , ELECTRICAL CONNECTION This unit is titted with mains electrical thermostatic control equipment and as such must only be connected to the relevant electrical supply. Please refer to the electrical specification label on the rear of the plug-in Powerstat controller. It is strongly recommended that you utilise a mains supply that is protected bya Residual Current Device (RCD). These are sometimes already present in your mains fuse box. If not, similar devices can easily be purchased from any electrical supplier or good hardware store which enable you to plug the Powerstat direclly into it. Any part of the cable between the Powerstat controller and the processor forms an integral part of the heating system and carries vital sensor information. Under NO circumstances must the cable, or any inter connecting cable between heaters, be severed otherwise serious injury or product damage may result. The cable is double insulated and therefore does not require separate earthing 00 NOT SWITCH ON Initial preparation tor all processors WE RECOMMEND THAT YOU FILL YOUR PROCESSOR WITH WATER AND SET YOUR REQUIRED WORKING TEMPERATURE BEFORE MIXING ANY PROCESSING CHEMISTRY. 1) Locate water core filler holes (12mm diameter) on the top of your processor. Note: There is one filler hole on Tandem processors and two on all other processors. 2) All 10 x 8 Processors must have each water core filled to within 25mm from the top. All other sizes have water level bungs located I FIG.l at the rear of the unit (Fig. 1). Remove each bung and fill each water core until water trickles out of the hole. Replace the bungs. NOTE: It is advisable to add a spoonful of domestic bleach to the water cores so as to prevent the build upofalgae. CHECK YOUR WATER CORE LEVELS EVERY WEEK.