Download Stack Command Line Interface User's Guide
Transcript
Chapter 6: Port Parameter Commands ENABLE SWITCH PORT Syntax enable switch port=port Parameter port Specifies the port to enable. You can specify more than one port at a time. Port numbers are specified in the following format: module ID.port number For instructions, refer to “Port Numbers in Commands” on page 40. Description This command enables a port. When a port is enabled, it forwards traffic. The default setting for a port is enabled. Example The following command enables ports 2.1 to 2.4: enable switch port=2.1-2.4 Equivalent Command set switch port=port status=enable For information, see “SET SWITCH PORT” on page 108. 104 Section I: Basic Operations