Download User Guide
Transcript
User Guide CCM-BOOGIE • High Performance CoreTM 2 Duo 3U CompactPCI® CPU Board Hot Swap Detection The CompactPCI specification added the signal ENUM# to the PCI bus to allow the board hot swapping. This signal is routed to the GPI3 of the ICH9. A System Management Interrupt (SMI) can be requested if ENUM# changes by insertion or removal of a board. Note that the CCM-BOOGIE itself is not a hot swap device, because it makes no sense to remove the system controller from a CompactPCI system. However, it is capable to recognize the hot swap of peripheral boards and to start software that is doing any necessary system reconfiguration. Power Supply Status (DEG#, FAL#) Power supply failures may be detected before the system crashes down by monitoring the signals DEG# or FAL#. These active low lines are additions of the CompactPCI specification and may be driven by the power supply. DEG# signals the degrading of the supply voltages, FAL# there possible failure. On the CCM-BOOGIE the signal FAL# is routed to the GPI4 and DEG# to the GPI5 of the ICH9. PXI Trigger Signals As an option, the CCM-BOOGIE supports four of the eight trigger signals of the PXI standard, as defined by National Instruments. The trigger signals are provided by the local SIO (Super-I/O) chip IT8761E. GPIO20/21 are routed to TRIG0/1, and GPIO26/27 are used to control TRIG6/7. These signals can also be used as GPIO lines in a non-PXI environment. © EKF -28- ekf.com