Download SecureLinx User's Manual
Transcript
Using the OSD Interface to Configure the SLK packets are lost during a short interval. This IP address does not need to be that of the controlled server but might be a border router or other "always-on" network component. To enable, enter an IP address to ping. To disable, type 0.0.0.0 (default). 14 HTTP Ping this address. The number designated for HTTP pings of addresses/ ports should be an IP address of a web (HTTP) server. The server will be asked to get the root page. If nothing is returned (zero length) or the connection fails, this error condition is considered active. To disable, type 0.0.0.0. 15 HTTP Ping this port number. The number designated for HTTP pings of addresses/ports should be an IP address of a web (HTTP) server. The server will be asked to get the root page. If nothing is returned (zero length) or the connection fails, this error condition is considered active. To disable, type 0.0.0.0. 16 Hotspot temperature. Displays the current internal temperature of the SLK. Third Monitor Settings Screen (SLK16 only) Note: SLK8 shows Current Time (monitor menu 2) and Timezone Offset (monitor menu 3). Figure 5-8. Monitor Settings Screen – SLK16 Only (3 of 3) 17 Video monitoring server port. Allows configuring of the Java port used for video monitoring to a custom port number. 18 Video monitoring view 1. First of four arrangements of screens that you can store as hexadecimal values. 19 Video monitoring view 2. Second of four arrangements of screens that you can store as hexadecimal values. 20 Video monitoring view 3. Third of four arrangements of screens that you can store as hexadecimal values. 21 Video monitoring view 4. Last of four arrangements of screens that you can store as hexadecimal values. 5-10 SecureLinx SLK Remote KVM User Guide