Download User's Manual

Transcript
2
Hysteresis width setting
Button
Operation
Display
CONTENTS
Press the
.
Press to display.
INTRODUCTION
Press to set.
Press the
button to move
the digit, press the
button to
change the numeric value, and
Set any value. set the hysteresis width.
MAIN
APPLICATIONS
& SETTING
METHODS
Press the
the setting.
Height
Steps
and
Warpage
Double
Sheet
Detection
3
Button
Operation
Display
Out
Eccentricity
and Surface
Deflection
* If the
button is pressed
when the cursor is at the
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
the setting will be canceled.
button to apply
Return to RUN mode
Thickness
Positioning
Default value: 0.000
Press to display.
[Change numeric value]
[Move digit]
BASIC
SETUP
button to display
Explanation of
Selection Menu
Press the
button to enable
setting of the hysteresis width.
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
Description of Operation
Hold down for
3 seconds
Description of Operation
Explanation of
Selection Menu
Hold down the
button for
three seconds to switch to the
RUN mode.
Important
• The hysteresis width for HIGH, PASS or LOW judgment is disabled when the hold function is
enabled.
DETAILED
SETTINGS
• The hysteresis width is enabled when the self-trigger is set.
TROUBLESHOOTING
SPECIFICATIONS
INDEX
SETTING
TRANSITION
CHARTS
88
Setting the Hysteresis
ZX2 User’s Manual