Download Installation Guide
Transcript
Important Information WARNING: When using electrical products, basic precautions should always be followed, including the following: DANGER: Risk of electric shock. Connect only to a circuit protected by a Ground-Fault Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB). Two dedicated 220-240 V, 20 A, 50/60 Hz services are required. Each must be protected by a GFCI or ELCB. A pressure wire connector marked ″Ground″ is provided within each wiring compartment. To reduce the risk of electric shock, connect this connector to the grounding terminal of your electric service or supply panel with a copper wire equivalent in size to the circuit conductors supplying this equipment. A pressure wire connector is provided on the exterior of the pump or control within this unit. Use this connector as a bonding conductor between this unit and all of the exposed metal in the vicinity, as needed to comply with local requirements. Provide access to components for servicing. Grounding is required. The unit should be installed and grounded by a qualified service representative. WARNING: Risk of electric shock. A licensed electrician should make all electrical connections. WARNING: Risk of electric shock. Disconnect power before servicing. WARNING: Risk of injury or property damage. Please read all instructions thoroughly before beginning installation, including the following requirements. NOTICE: Follow all local plumbing and electrical codes. Product Information Product Modifications WARNING: Unauthorized modifications may cause unsafe operation and poor performance of the custom system. Do not remove the pump from the pump box or make non-recommended modifications to the system. Unauthorized modifications could adversely affect the performance and safe operation of the unit. Kohler Co. shall not be liable under its warranty, or otherwise, for personal injury or damage caused by any unauthorized modification. The system is not designed for steam applications, and may not perform in a satisfactory manner as a steam unit. Product Inspection Carefully unpack and inspect all components for damage. Return all materials to the cartons during construction to prevent damage. Factory-Assembled Features Some components have been factory installed and others will require assembly. Components include a tower with eight pre-assembled jets, a pump, a heater, a control, a footbath and an enclosure. Connections and Service Access Before installation, ensure proper access to the final connections. NOTICE: Provide unrestricted service access to the pump. You must provide access for servicing the pump, heater and control. The access must be located immediately next to the pump. 1032110-2-E 2 Kohler Co.