Download Service Manual
Transcript
Hydrostatic Drive Pump 2. Place a Do Not Operate Tag on both the ignition key switch and steering wheel, stating that the machine should not be operated. 17. Carefully remove the drive pump from the machine. Avoid causing damage to the drive pump or surrounding parts. 3. Open the engine cover. Allow the system fluids to cool. 18. Lift the drive pump clear of the machine and lower it onto suitable supports or secure it to a stand built especially for drive pump or engine service. Secure the drive pump so that it will not move or fall. 4. Remove rear cover to allow easier access to the drive pump. 5. Remove belly pan from under engine. 6. Drain the hydraulic oil reservoir. Refer to Section 8.5, “Hydraulic Reservoir.” 6.5.2 7. Remove the battery negative (-) cable from the battery negative (-) terminal. Note: Contact the JLG Service Department if internal drive pump repair is required. 8. Thoroughly clean the drive pump and surrounding area, including all hoses and fittings, before proceeding. 6.5.3 9. Place a suitable receptacle under the drive pump. Drive Pump Inspection and Internal Repair Drive Pump Installation 1. Use a hoist or overhead crane and sling attached to the drive pump. Raise and position the drive pump within the chassis. 2. Align the input shaft, align the drive pump bolt holes with the two holes in the bell housing. Install the two bolts and washers and torque to 240 lb-ft (240 Nm). 2 1 3. Remove the hoist or overhead crane and sling. 4. Align the input shaft, align the bolt holes of the implement pump to the drive pump. Install the two bolts and washers and torque to 160 lb-ft (217 Nm). 5. Connect the drive pump shift solenoid wiring harness connectors. 6. Secure the wiring harness to the drive pump housing. 7. Uncap and connect all the hydraulic hoses and tubes. MX0870 10. Label and disconnect both shift solenoid wiring harness connectors. 11. Label, disconnect and cap the all hydraulic hoses and tubes attached to the drive pump. Cap all fittings and openings to keep dirt & debris from entering the hydraulic system. 8. Install the rear cover and belly pan. 9. Refill the hydraulic oil reservoir. Refer to Section 8.5, “Hydraulic Reservoir.” 10. Connect the (-) negative battery cable. 11. Start engine and check for any hydraulic leaks. 12. Close and secure the engine cover. 12. Wipe up any spilled hydraulic oil. 13. Loosen and remove both bolts holding the implement pump (1) to the drive pump (2). 14. Pull the implement pump away from the drive pump. 15. Connect a lifting strap or chain to the top of the drive pump, and to a suitable hoist or overhead crane. Operate the hoist or crane to remove slack from the chain, but DO NOT raise the drive pump at this time. 16. Loosen and remove the two bolts holding the drive pump to the engine bellhousing. 6.4 534D-9, 534D-10 & 544D