Download section i - Sensible Tech
Transcript
D.8e Package overhang at last station D.8f Position of the Transfer conveyor's outfeed guides When a package is being presented to the gripper arm (last station of the Transfer conveyor) the package should have only the trailing edge of the folded document held by the flat green belts. Positioning the trailing edge of the document at the centerline of the lower, forward-most shaft accomplished the desired document position. When the gripper arm removes a package from the Transfer conveyor the flat green belts of the Transfer conveyor will creep if more than 3/4 of inch of the package is being pinched by the flat green belts. The creeping of the flat green belts will cause the packages to become improperly gapped in the Transfer conveyor. It is recommended that the Transfer conveyor arm be positioned parallel to the deck of the inserter and it should be close enough to the deck so the outfeed guides do not need to drastically deflect the folded document. This will help prevent the flat green belts from creeping and ease the extraction force required to remove the folded document. D.8g Fold quality Consistent fold quality is required or the package size can vary enough to cause the Transfer conveyor packages to be improperly positioned in the conveyor. D.8h Transfer conveyor package spacing problem If package spacing problems occurs in the Transfer conveyor it should be purged of all the remaining documents in it. This will insure that documents will be properly positioned. Transfer Conveyor Figure SMART FEEDER SERVICE MANUAL ISSUE 09/00 REPAIR INFORMATION SECTION D – PAGE 79