Download section i - Sensible Tech

Transcript
D.8e
Package overhang at last station
D.8f
Position of the Transfer conveyor's outfeed
guides
When a package is being presented to the gripper arm
(last station of the Transfer conveyor) the package should
have only the trailing edge of the folded document held
by the flat green belts. Positioning the trailing edge of the
document at the centerline of the lower, forward-most
shaft accomplished the desired document position.
When the gripper arm removes a package from the
Transfer conveyor the flat green belts of the Transfer
conveyor will creep if more than 3/4 of inch of the
package is being pinched by the flat green belts. The
creeping of the flat green belts will cause the packages to
become improperly gapped in the Transfer conveyor.
It is recommended that the Transfer conveyor arm be
positioned parallel to the deck of the inserter and it
should be close enough to the deck so the outfeed
guides do not need to drastically deflect the folded
document. This will help prevent the flat green belts from
creeping and ease the extraction force required to
remove the folded document.
D.8g
Fold quality
Consistent fold quality is required or the package size can
vary enough to cause the Transfer conveyor packages to
be improperly positioned in the conveyor.
D.8h
Transfer conveyor package spacing problem
If package spacing problems occurs in the Transfer
conveyor it should be purged of all the remaining
documents in it. This will insure that documents will be
properly positioned.
Transfer Conveyor Figure
SMART FEEDER SERVICE MANUAL
ISSUE 09/00
REPAIR INFORMATION
SECTION D – PAGE 79