Download Fuel System

Transcript
Diagnostics and Troubleshooting
Fuel System Specifications
Fuel System Specifications
Mechanical water‑cooled (plunger/
diaphragm)
Fuel lift pump type
Fuel pump pressure (maximum)
20–41 kPa (3–6 psi)
Plunger stroke
5.9 mm (0.232 in.)
Fuel tank capacity
Accessory
Fuel injection system
Sequential
Fuel injector resistance
10–13.5 ohms
Pressure
Electric fuel pump
Mechanical fuel pump
290–303 kPa (42–44 psi)
Engine running ‑ after five minutes
295 kPa (43 psi)
Minimum pressure at 1000 RPM with pinched fuel
outlet line
20.7 kPa (3 psi)
Minimum vacuum at 1000 RPM with fuel inlet line
pinched
102 mm Hg (4 in. Hg)
Vapor separator float height ‑ float needle seated
36.5–39.5 mm (1.437–1.555 in.)
Idle RPM (neutral) warm
750 ± 25 RPM
Idle RPM (forward gear) warm
750 ± 25 RPM
Lubricant, Sealant, Adhesives
Tube Ref No.
25
Description
Liquid Neoprene
Where Used
Part No.
Grounds and ring terminals
92- 25711 3
Special Tools
CDS G3 Diagnostic Interface Tool With
Harness
8M0046124
Provides diagnostic support for the Computer Diagnostic System.
41993
CDS G3 Termination Harness
84‑8M0045065
43351
Fuel Pressure Gauge Kit
Contains termination resistors to allow communication when G3 is connected to
the engine's diagnostic connector.
91‑881833A03
Tests the fuel pump pressure; can be used to relieve fuel pressure.
2807
Page 3B-2
90-883064R03 NOVEMBER 2010