Download Functional Specification
Transcript
Document type: System: Order reference: Document No Functional Specification V30259 5101874 T1705 User: User reference: Version: Page: Sanofi- Synthelabo Malvern, PA Renovations B 21/60 3.5.3.1.2 An information text function don't affect the door control, refer to DOOR FUNCTIONS 3.5.3.1.3 A specific text shall highlight a certain condition that will prevent the machine from starting a cycle, i.e. “Prevented-start messages”, or is used to show conditions that are not sufficient to cause a failure of the cycle, i.e. “Service messages”, “Process report messages” and “Process information messages” 3.5.3.1.4 The function does not require any reset procedure, it disappears when the fault condition is gone 3.5.3.1.5 The cycle response is non-GMP critical resulting in a ”Process OK” printout on the report 3.5.3.2 Specific features for Prevented-start messages 3.5.3.2.1 The messages are associated with conditions that will prevent a cycle from starting 3.5.3.2.2 The start button indication-light will not be activated 3.5.3.2.3 Messages are displayed during five (5) seconds upon start trials on the operator panels when start button is pressed 3.5.3.3 List of Prevented-start messages 3.5.3.3.1 Steam Generator Error [prevents start and is shown during 5 seconds] 3.5.3.3.2 Step Key Is On [prevents start and is shown during 5 seconds] 3.5.3.3.3 Printer Active [a printing process printer prevents start for 15 minutes and is shown during 5 seconds] 3.5.3.3.4 Active Alarms [still active alarms prevents start and is shown during 5 seconds] 3.5.3.3.5 Door Seal Pressure [faulty status prevents start and is shown during 5 seconds] 3.5.3.3.6 Door not closed [prevents start and is shown during 5 seconds] 3.5.3.3.7 Door Key Switch [a door interlocked for closing prevents start and is shown during 5 seconds] 3.5.3.3.8 Jacket Temp Low [If the jacket temperature is too low compared with the jacket control temperature] 3.5.3.3.9 Jacket Temp High [If the jacket temperature is too high compared with the jacket control temperature] 3.5.3.3.10 Bursting Disc [If the bursting disc is leaking or broken] 3.5.3.4 Specific features for Service messages 3.5.3.4.1 The messages are constantly active in standby when the condition is active 3.5.3.4.2 The messages do not prohibit the start of a process 3.5.3.5 List of Service messages 3.5.3.5.1 Battery Error [is always on when the conditions occurs, does not affect the process at all] 3.5.3.5.2 Manual Outputs [is always on when a DO or AO is manually set and does not affect the process] 3.5.3.6 Specific features for Process report messages 3.5.3.6.1 The messages are only recorded on the process report 3.5.3.7 List of Process report messages 3.5.3.7.1 Process OK [is set upon a successful process] Rev.B