Download Storage Map Template for PVA 2
Transcript
Subsystem Introduction 1–17 Maintenance Port You can access the controller to modify CLI commands (add a disk drive, remove a disk drive, and so on) in two ways: ■ Through a local terminal/PC via the maintenance port ■ Through a remote terminal—sometimes called a virtual terminal or host console—via the host. It is recommended that you use a local terminal to carry out the troubleshooting and servicing procedures in this manual. See “Establishing a Local Connection to the Controller,” page 4-2, for more information about connecting the array controller with a maintenance port cable. Controller Utilities and Exercisers The controller software includes the following utilities and exercisers to assist in troubleshooting and maintaining the controller and the other modules that support its operation: ■ Fault Management Utility (FMU) ■ Virtual Terminal Display (VTDPY) ■ Disk Inline Exerciser (DILX) ■ Configuration Utility (CONFIG) ■ HSUTIL ■ Code Load and Code Patch Utility (CLCP) ■ Clone Utility (CLONE) ■ Change Volume Serial Number Utility ■ Device Statistics Utility ■ Field Replacement Utility (FRUTIL) Each of these is described in the paragraphs that follow. Fault Management Utility The Fault Management Utility (FMU) provides a limited interface to the controller fault-management system. As a troubleshooting tool, you can use the FMU to: ■ Display the last-failure and memory-system-failure entries that the fault-management software stores in controller nonvolatile memory (NVMEM).