Download 7155 - ALL ACTIVE SOLUTIONS June 2009

Transcript
7155
Solution ID
Warm-up, wrong display, incorrect operation, lock-up
TAUS0625207EN*
Solution Usage
0
Description
SC46-99. When the front door is opened/closed the code goes awaybutwill reoccur.
Solution
CAUSE: This code is generated if the EDH memory module is not functioning or not connected properly.
SOLUTION: Try removing the optional memory and reseating it. This usually resolves the problem. If this fails to correct the issue, try removing the optional
memory completely. If the code still will not clear, the ICB has failed and should be replaced (Image Control Board - p/n 4396-1278-01 for
7255/7272/Di5510/Di7210 ;p/n 56AA-9012 for 7155/7165 ; p/n 4024-2057-01 for Di551/Di650 ).
Solution ID
TAUS0629420EN*
Solution Usage
0
Solution Usage
0
Description
Scanner unit is slamming against the left side of the machine frame when copying from the platen.
Solution
CAUSE: Failed SCB (scanner control board).
SOLUTION: Replace the SCB (p/n 56AA-9091).
Solution ID
TAUS0641737EN*
Description
'This device does not support scanning function' error message when retrieving address book from MFP/Controller.
Solution
CAUSE: The engine address book was trying to download via thecontroller network port.
SOLUTION: To download or upload address book informationconnect to the engine network port. To configure TCP/IP address on the engine, perform the
following:
1. Press HELP (?) to access Key Operator mode.
2. Press (1. System Initial)
3. Set engine's TCP/IP address, subnet mask and gateway.
4. Exit key operator mode.
5. Download the address book from the engine.
Solution ID
TAUS0645408EN*
Solution Usage
0
Description
SC90-01 at power up.
Solution
CAUSE: CN207 and CN217 are connected in the incorrect sockets on the PRCB (Printer Control Board).
SOLUTION: Verify CN207 and CN217 are connected in the correct sockets (both are 12-pin connectors and can be interchanged). All wires of CN217 are
violet.
Please, also:
Check ICP1 on the ADUDB. It is possible that this is OPEN.
Inspect the wiring harness, solenoids, fans and motors in the ADU section.
Check 24V DC outputs on the ADUDB to isolate a short to ground/pinched wire.
Replace the ADUDB if necessary (p/n 4026-1006-01 for the Di551; p/n 4024-2892-01 for the Di650; p/n 56EA-9040 for the 7155; p/n 56AA-9040 for the
7165).
Note : ICP1 is not a replaceable part. It is not a fuse; it is a semiconductor device (like a transistor or diode).
WARNING : DO NOT ATTEMPT TO SHORT across ICP1.
SPECIAL NOTE : Solution contribution by David Silverstein, Workgroup/SSD
Solution ID
TAUS0703493EN*
Solution Usage
0
Description
Copyright 2009, Konica Minolta Business Solutions U.S.A., Inc.
June 2009
37