Download Seagate Crystal Reports

Transcript
7165
CAUSE: Image data decompression from the memory to the printer is not completed within the specified time.
SOLUTION: Reseat memory and all connectors on the Image CB.
SPECIAL NOTE: Solution provided by Edward Johnson - Copy Service & Supply, Statesville, NC.
Solution ID
TAUS0639442EN*
Solution Usage
0
Solution Usage
0
Description
How to enable/disable the banner page generated by the main body.
Solution
To enable/disable the banner page, perform the following:
1. Press the mode key and select Printer mode.
2. Press Controller set.
3. Banner page is the top item and is already highlighted. Press OK.
4. Select either OFF or ON and press OK.
5. Press cancel to return to the normal printer screen.
Solution ID
TAUS0639446EN*
Description
Banner pages are being generated even with all banner selections/options disabled.
Solution
CAUSE: The NIC firmware is corrupted.
SOLUTION: Reset the NIC to factory settings and upgrade to the latest level firmware version. To reset the IP511 NIC to factory settings, perform the
following:
1. Power down the IP unit and remove the small rear IP511 cover.
2. Set jumper OP2 to the lower 2 pins (bottom and middle) for factory initialization.
3. Power the IP unit ON and leave it on for five minutes.
4. Power down the IP unit and reset jumper OP2 to the upper 2 pins (upper and middle).
5. Install the rear cover.
6. The card should now be initialized and should print a status page once both the IP unit and the printer have come to a ready state.
Solution ID
TAUS0639603EN*
Solution Usage
0
Description
A status page is not printed at power up and also can not be printed from the web utility when browsing to the NIC.
Solution
CAUSE: ECM mode is enabled.
SOLUTION: Temporarily disable ECM mode if a status page is needed. All of the information on the status page can be viewed when browsing to the NIC so
disabling ECM mode is not required.
.
Solution ID
TAUS0639913EN*
Solution Usage
0
Description
FS110, Spare parts setting of new stapler jig.
Solution
See T20040115A1 for details.
Note: To view the above PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:
[[http://www.adobe.com/products/acrobat/readstep2.html| URL http://www.adobe.com/products/acrobat/readstep2.html]]
* Trademark ownership information
Solution ID
TAUS0639915EN*
Solution Usage
0
Description
FS210, Spare parts setting of new stapler jig.
Solution
See T20040115A1 for details.
Note: To view the above PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:
Copyright 2009, Konica Minolta Business Solutions U.S.A., Inc.
June 2009
152