Download Technical Manual

Transcript
2-1
Safety
2.1 Introduction
The QuanX system has been designed to meet all safety requirements applicable to industrial
electrical and radiation devices. However, potential hazards exist in the operation and service of
all electrical equipment. In addition, the QuanX and the OEM equipment built into it present
potential hazards specific to their modes of operation.
Spectrace Instruments provides information about its products and the potential hazards
associated with the use and care of these products. The instructions and information presented in
this manual are intended to help the service technician develop safe habits for working on the
QuanX. WARNINGS, CAUTIONS and NOTES are an integral part of the instructions and in
accordance with federal, UL and industry standards, are used as follows:
WARNINGS indicate that failure to follow instructions or precautions can lead to injury or
death.
CAUTIONS indicate that failure to follow instructions or precautions can lead to damage to
equipment.
NOTES convey information that can help the user (operator or service technician) get
optimum performance from the equipment. The use of NOTES implies no hazard to users or
equipment.
Spectrace Instruments makes no representation that the readers of this manual are qualified, or
that the act of reading this manual renders them qualified, to install, troubleshoot, maintain or
repair the QuanX system.
Service technicians must be thoroughly familiar with and understand the safety procedures, know
how to recognize hazardous or potentially hazardous conditions, and know how to take adequate
precautions to protect themselves and others from possible injury.
Address questions and comments regarding safety to:
Spectrace Instruments
1275 Hammerwood Avenue
Sunnyvale, CA 94089
(408) 744-1414
Attn: Customer Service
2.1.1 Responsibility for Safe Operation
X-ray producing equipment should be used only under the guidance and supervision of a
responsible qualified person. All equipment operators must be given adequate radiation safety
instruction as specified by governing state regulations.
Adequate precautions should be taken to make it impossible for unauthorized or unqualified
persons to operate this equipment or to expose themselves or others to its radiation or electrical
dangers.
Before utilizing the equipment it is suggested that all persons designated or authorized to operate
it, or supervise its operation, should have a full understanding of its nature and should also
become familiar with established safe exposure factors by a careful study of the appropriate
documents listed below:
Spectrace Instruments QuanX Technical Manual