Download warning - Sweets
Transcript
140.010-IOM (JUL 2014) Page 2 ECOSS™ EVAPORATIVE CONDENSERS INSTALLATION - OPERATION - MAINTENANCE IMPORTANT! READ BEFORE PROCEEDING! This manual provides the information needed for safe installation, operation, and maintenance for ECOSS™ Evaporative Condensers. Close attention to the instructions provided in this manual will ensure proper installation and operation, and a long satisfactory unit life. It is strongly recommended that one becomes fully familiar with this manual prior to operating or working on an ECOSS™ Evaporative Condenser. After installation the unit must be properly connected to an appropriately designed and installed refrigeration system. The engineering plans, piping layouts, etc., must be detailed in accordance with local codes and applicable industry standards and practices. Units should be rigged and installed as outlined in this manual. These procedures should be reviewed in detail prior to the actual rigging operation to acquaint all personnel with the procedures to be followed. If any questions or comments arise regarding this manual, we encourage you to call your sales representative. CHANGEABILITY OF THIS DOCUMENT In complying with Johnson Controls policy for continuous product improvement, the information contained in this document is subject to change without notice. While Johnson Controls-Frick makes no commitment to update or provide current information automatically to the manual owner, that information, if applicable, can be obtained by contacting the nearest Frick Factor or the nearest Frick Sales office. It is the responsibility of operating/service personnel to verify the applicability of these documents to the equipment in question. If there is any question in the mind of operating / service personnel as to the applicability of these documents, then prior to working on the equipment, they should verify with the owner whether the equipment has been modified and if current literature is available. WARNING External wiring is NOT to be connected inside an ECOSS™ factory mounted electrical panel unless specifically indicated as required field wiring on the JCI - Frick electrical drawings provided. Devices such as relays, switches, transducers and controls may NOT be installed inside the Frick ECOSS™ electrical panel. NO external wiring is allowed to be run through the Frick ECOSS™ electrical panel. All wiring must be in accordance with Johnson Controls-Frick published specifications and must be performed ONLY by qualified Johnson Controls-Frick personnel. Johnson ControlsFrick will not be responsible for damages/problems resulting from improper connections to the controls or application of improper control signals. Failure to follow this will void the manufacturer’s warranty and may cause serious damage to property or injury to persons. NOTICE This manual, in combination with the applicable cooling coil data, unit G&A drawing, unit electrical drawing, and structural support drawing, provides the information necessary to safely install and start up a Frick ECOSS™ unit. Due to the possibility of customization associated with the ECOSS™ product line, there may be areas beyond the scope of this manual. If there are any questions about a special application lacking the required information, please contact the installing contractor or your local Frick Sales Office. SAFETY PRECAUTION DEFINITIONS WARNING Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. Indicates a potentially hazardous situation or practice which, if not avoided, will result in death or serious injury. CAUTION Indicates a potentially hazardous situation or practice which, if not avoided, will result in damage to equipment and/or minor injury. NOTICE Indicates an operating procedure, practice, etc., or portion thereof which is essential to highlight. DANGER