Download End Float
Transcript
Twin Cam – Cam side 1st model – The drive cam (longer of the 2 cams) has a woodruff keyway and ran in a ball bearing. The cam drive sprocket had a key made into it. The bolt that held it on was made wrong. The head nut should be 90 degrees to the shank, but wasn’t on many models. It would sometimes back off. The first warranty was simply 2 bolts and 2 washers. Sometimes the drive cam ball bearing would fail. The cam would lock up briefly and the engine would strip the key out of the gear. The second warranty was a new cam plate, cams, oil pump and 4 tappets. H-D then went to a splined end cam that has a master spline that is wider than the others. It will only go on one way. When the bearing failed the engine kept running! BAD!! In late 2000, H-D went to a needle bearing. The needle bearing made it much easier to change the cams. There was no need to press a cam into the needle bearing. The big end of the cam (case end) always used needle bearings. No dogbones, no thrust plates and no alignment reaming is necessary. No bushings. The tool for cam removal is the JIMS #1277 (3 piece). The bearings are pressed on with one of the pieces. That tool: Bears on the outer edge of the bearing to prevent damage Insures alignment Seats the bearing to the proper depth One piece of the tool presses the cam into the plate. REMOVE THE CAM BEARING RETAINING PLATE BEFORE REMOVING THE CAMS!! 4 screws Later models had longer cam sprocket retaining bolts 60