Download SCS

Transcript
CK SUSP INDICATOR LAMP CIRCUIT
[AIR LEVELIZER CONTROL SYSTEM]
< DTC/CIRCUIT DIAGNOSIS >
CK SUSP INDICATOR LAMP CIRCUIT
Description
INFOID:0000000006256089
Air levelizer control module transmits CK SUSP indicator lamp signal to combination meter via CAN communication, when setting of standard vehicle height is incomplete. Based on the signal, combination meter turns
CK SUSP indicator lamp ON.
Component Function Check
INFOID:0000000006256090
1.CHECK CK SUSP INDICATOR LAMP OPERATION
1.
2.
3.
CONSULT-III
Turn ignition switch ON.
Select “WARNING LAMP” in “Active Test” in “E-SUS”.
While operating test item, check that the CK SUSP indicator lamp activates.
ON
OFF
: CK SUSP indicator lamp turns ON
: CK SUSP indicator lamp turns OFF
Is the inspection result normal?
YES >> INSPECTION END
NO
>> Refer to SCS-90, "Diagnosis Procedure".
Diagnosis Procedure
INFOID:0000000006256091
1.PERFORM SELF-DIAGNOSIS
CONSULT-III
1. Turn ignition switch ON.
2. Select “Self Diagnostic Result” in “E-SUS”.
Are any DTC detected?
YES >> Refer to SCS-59, "DTC Index".
NO
>> GO TO 2.
2.CHECK COMBINATION METER
Check combination meter. Refer to MWI-29, "On Board Diagnosis Function".
Is the inspection result normal?
YES >> Replace the air levelizer control module. Refer to SCS-94, "Removal and Installation".
NO
>> Repair or replace the combination meter. Refer to MWI-85, "Removal and Installation".
Revision: 2010 May
SCS-90
2011 QX56