Download Quick Reference Guide

Transcript
BRAKES 10-9
Calipers
WARNING
To avoid serious injury, never place your fingers or
palm inside the caliper opening. If you apply compressed air into the caliper, the piston may crush
your hand or fingers.
the dust seal and fluid seal.
• Remove
Remove
the
bleed valve and rubber cap.
•
Assembly Notes
• Tighten the bleed valve to the specified torque.
Torque - Bleed Valve: 7.8 N·m (0.80 kgf·m, 69 in·lb)
is recommended that the fluid seal [B], which is re• Itmoved,
be replaced with a new one.
Replace
the dust seals [A] if they are damaged.
• Apply brake
the cylinders, pistons, and fluid seals
• (piston seals),fluidandtopush
the pistons [C] into the cylinders
•
by hand. Take care that neither the cylinder nor the piston
skirt get scratched.
Install the dust seal around the piston. Check that dust
seal is properly fitted into the grooves in the piston and
caliper.
the caliper holder shaft rubber boot and dust
• Replace
cover if they are damaged.
a thin coat of silicone grease to the caliper holder
• Apply
shafts and holder holes (silicone grease is a special high
•
•
temperature, water-resistant grease).
Install the anti-rattle spring [A] in the caliper as shown.
Install the pads (see Pad Installation).
Fluid Seal Damage Inspection
The fluid seal around the piston maintains the proper
pad/disc clearance. If this seal is not in good condition,
pad wear will increase, and constant pad drag on the disc
will raise brake and brake fluid temperature.
Replace the fluid seals under any of the following conditions: (a) fluid leakage around the pad; (b) brakes overheat; (c) there is a large difference in left and right pad
wear; (d) the seal is stuck to the piston. If the fluid seal is
replaced, replace the dust seal as well. Also, replace all
seals every other time the pads are changed.
•
Dust Seal and Cover Damage Inspection
that the dust seals and covers are not cracked,
• Check
worn, swollen, or otherwise damaged.
If they show any damage, replace them.
Piston Cylinder Damage Inspection
inspect the piston and cylinder surfaces.
• Visually
Replace the cylinder and piston if they are badly scored
or rusty.