Download Operator`s Guide - Oracle Documentation

Transcript
VIew
VIEW Command
If video monitors are attached to the LSM, the VIew command enables the operator to
visually inspect internal components of the LSM, using the robot’s cameras.
Notes:
• The VIew command is not supported for the SL3000 and SL8500 libraries,
which do not contain lights or cameras.
• The VIew command requires exclusive use of the robot. This command impacts
library performance because the robot is not available for other work while it is
viewing a component.
• An SMF record is written each time the VIew command is issued (if subtype 8 is
specified in PARMLIB) to document robot activity.
The following components can be viewed using this command:
•
•
•
•
•
CAP cells
cartridge storage and diagnostic cells
drives
playground cells
pass-thru port (PTP) cells.
Note: Sun StorageTek does not provide video monitors that can be attached to an LSM.
Each LSM is equipped with ports which allow third-party video monitors to be connected
to the robot’s vision system.
An HSC message is displayed on the system console when the robot is in position to view
the specified component. This notifies the operator that the camera is ready, and provides
the following information about the component being viewed:
•
•
•
•
•
•
ACSid
LSM number
camera number
number of seconds the camera is to remain focused
component name
component location.
The message remains highlighted on the console until either the time interval expires, or
the operator responds to the message. The operator is not required to respond to the
message, but by doing so, can cancel the VIew command and resume normal operations.
Chapter 2. Commands, Control Statements, and Utilities 229
Rev. E, 5/31/09 - 312597201