Download PDF

Transcript
Dismantling Procedures CR-H, CRN-H 32•45•64•90
Back-to-Back Seal (continued)
16
18
17
Slide the
threaded seal
retainer off the
shaft. Next, slide
the Retaining
Washer
Remove the Rotating Seal Face
(Pos. 104b). Then, use adjustable
pliers or a 53 mm (2-1/8 in.) wrench
to remove the Threaded Seal Retainer
(Pos. 148).
19
(Pos. 59e) off
the shaft.
20
Using a small flat tip screwdriver, pry/
loosen the stationary seal from the
Connecting Pipe (Pos. 149). Slide the
seal off the shaft.
21
Loosen and
remove the
8 mm hex socket
Retainer Screws
(Pos. 58d).
Slide/remove the middle pump head
(Pos. 20).
22
Remove the Connec ting Pipe
(Pos. 149) and the innermost Pump
Head (Pos. 2).
4
Remove
the Connecting
Pipe Retainer
(Pos. 58c).
Remove the Spacing Ring (pos. 116).
23
Place the connecting pipe into one
of the pump heads. Use 00SV2128
and a rubber mallet to drive out the
Retainer Ring (Pos. 47h) and Bushings
(Pos. 47g).
24
Remove the O-rings (Pos. 109a and
109b). For reassembly of the seal and
connecting pipe, go to the Reassembly
section, step 17. To continue
disassembly, proceed to step 40.