Download ARM Cross Development with Eclipse
Transcript
toasters, cars, fighter jets and Roomba vacuum cleaners. This is where the real action is in the field of computer science and engineering. It’s called “embedded software development”. Can today’s young student or home hobbyist tired of watching Reality Television dabble in microcomputer electronics? The answer is an unequivocal YES! Most people start out with projects involving the Microchip PIC series of microcontrollers. You may have seen these in Nuts and Volts magazine or visited the plethora of web sites devoted to PIC computing. PIC microcomputer chips are very cheap (a couple of dollars) and you can get an IDE (Integrated Development Environment), compilers and emulators from Microchip and others for a very reasonable price. Another inexpensive microcontroller for the hobbyist to work with is the Rabbit microcomputer. The Rabbit line is an 8-bit microcontroller with development packages (board and software) costing less that $140. I’ve longed for a real, state-of-the-art microcomputer to play with. One that can do 32bit arithmetic as fast as a speeding bullet and has all the on-board RAM and EPROM needed to build sophisticated applications. My prayers have been answered recently as big players such as Texas Instruments, Philips and Atmel have been selling inexpensive microcontroller chips based on the 32-bit ARM architecture. These chips have integrated RAM and FLASH memory, a rich set of peripherals such as serial I/O, PWM, I2C, SSI, Timers etc. and high performance at low power consumption. A very good example from this group is the Philips LPC2000 family of microcontrollers. The LPC2106 has the following features, all enclosed in a 48-pin package costing about $11.88 (latest price from Digikey for one LPC2106). Key features 16/32-bit ARM7TDMI-S processor. 64 kB on-chip Static RAM. 128 kB on-chip Flash Program Memory. In-System Programming (ISP) and InApplication Programming (IAP) via on-chip boot-loader software. Vectored Interrupt Controller with configurable priorities and vector addresses. JTAG interface enables breakpoints and watch points. Multiple serial interfaces including two UARTs (16C550), Fast I²C (400 kbits/s) and SPI™. Two 32-bit timers (7 capture/compare channels), PWM unit (6 outputs), Real Time Clock and Watchdog. Up to thirty-two 5 V tolerant general-purpose I/O pins in a tiny LQFP48 (7 x 7 mm2) package. 60 MHz maximum CPU clock available from programmable on-chip PhaseLocked Loop with settling time of 100 us. On-chip crystal oscillator with an operating range of 1 MHz to 30 MHz. Two low power modes: Idle and Power-down. Processor wake-up from Power-down mode via external interrupt. Individual enable/disable of peripheral functions for power optimization. Dual power supply: o CPU operating voltage range of 1.65 V to 1.95 V (1.8 V +- 8.3 pct.). o I/O power supply range of 3.0 V to 3.6 V (3.3 V +- 10 pct.) with 5 V tolerant I/O pads.