Download Cod. vec671 r3

Transcript
Error protocol
13.3
Troubleshooting
The list shows a selection of possible measures if problems occur. Not all problems listed will result in
an error message.
Problem
Error message
Shut-down
Cause
Brake resistor connection
Brake resistance
High generator power
High DC-link voltage
Main phase failure
Overcurrent
Short-circuit or overload
Earth fault
Overtemperature
Electromagnetic interference
Overfrequency
Parameter setting
not possible.
Enable is switched on
and motor is running.
Access limited.
Setup is active.
Changes disabled by
password.
Motor does not
turn after pressing of RUN.
Parameter setting
No enable
Error in control cables
Troubleshooting
Possible remedy
See chapter 13.1.1 “Error messages”.
Check.
Check value. Reduce value if necessary.
Reduce deceleration value.
Check brake resistance.
Check brake resistor connection.
Reduce deceleration value.
Check DC-link voltage limitation (P680).
DC-link voltage higher than brake chopper trigger
threshold (P506). Check value. Increase value if necessary.
DC-link voltage higher than motor chopper trigger
threshold (P507). Check value. Increase value if necessary.
Check mains connection.
Check motor data.
Check motor connection.
The parameterizable motor circuit breaker (P571) has
been triggered. Short-circuit at motor connection or
overload.
Check load for earth fault.
Overload. Reduce load and ensure sufficient cooling.
Comply with permissible ambient conditions.
Reduce output power or switching frequency.
Check EMC.
Switch-off limit (P417) exceeded. Increase value if
necessary.
Maximum frequency increase (P681) of DC-link voltage limitation exceeded. Increase value if necessary.
Most parameters cannot be written during operation.
Switch off enable and select "Para" menu on operator panel.
Select higher control level (P28).
Wait until setup is finished and the message "ready"
is displayed.
Entry must correspond to password (P27).
For P412, select "3 - Control via keypad" or "4 - Control via keypad or contacts" (factory setting).
Check P418 (Minimum frequency) and P419 (Maximum frequency).
Switch on both enable inputs STOA and STOB.
Check control cable connections.
331
06/2013
Operating Instructions Agile