Download User`s Guide for OPTIC 2
Transcript
Optic 2 Issue 1 _______________________________________________ 11 Fault Diagnosis This section details the warning and fault conditions on the Optic 2 and the states within the software which they are valid. 11.1 Warnings Warnings are only detected after a method has been selected and loaded. Warnings are displayed until canceled, by pressing the Menu Enter key, and are not re-enabled until the instrument is switched off and back on again. 11.1.1 Ramp Rate The Ramp Rate warning is enabled and valid when a ramp temperature output is being performed and the ramp temperature is more than 50°C above or below the set point, (75°C above or below a set point above 450°C). On detection of this condition the display reads: "Warning : Ramp Rate". 11.1.2 Carrier Gas The Carrier Gas warning is enabled and valid when the carrier gas pressure is at zero. On detection of this condition the display reads: "Warning : Carrier Gas". 11.2 Faults Fault conditions on the Optic 2 are non-recoverable. To clear a fault condition the instrument must be switched off, the fault rectified and the instrument switched back on again. 11.2.1 Thermocouple Fault The thermocouple fault occurs when the thermocouple fails, the thermocouple cable is disconnected, or if the GC is not earthed. The condition is flagged up by a hardware interrupt. On detection of the fault the display reads: "Fault : Thermocouple". The heater output is disabled to put the instrument in a safe condition. The instrument must be switched off and the fault rectified. 11.2.2 Temperature Fault The temperature fault occurs should the current injector temperature be 50°C, or higher, above the maximum temperature set in the Configure Menu, and rising. On detection of the fault the display reads: "Fault : Temperature". The heater output is disabled to put the instrument in a safe condition. The instrument must be switched off and the fault rectified. 11.3 Troubleshooting _______________________________________________ Fault Diagnosis Page 11.1