Download PDF ActiveBatch User`s Guide

Transcript
Chapter 9 - Using the ActiveBatch Command-Line Interface
/DENY=(account:access,…)
This qualifier is used to deny an account access that the account may also obtain through a group.
account refers to the WinNT account name (or group) and access refers to one or more of the
following keywords: READ, WRITE, DELETE, EXECUTE, TAKEOWNERSHIP, TRIGGER,
TRIGGERPARAM and TRIGGERQUEUE. To specify more than one level of access to be denied,
separate each access with a colon. Multiple accounts may be specified by delimiting each
account/access string with a comma.
/DESCRIPTION=”string”
This qualifier is used to set the pending job’s description specified at job submission time.
/DOCUMENTATION=”string”
This qualifier is used to associate a documentation reference with the job.
/EVERY=(MINUTE=mm,… , HOUR=hh,… , WEEKDAY=ddd,… , DAY=dd,… ,
MONTH=mm,…)
Note: This qualifier while supported is obsolete and has been superceded by the /SCHEDULE
qualifier. This qualifier indicates that a rescheduled job entry is to be created. By default, if all
keywords are omitted, a job entry is created that will execute at midnight each day. Valid keywords are
as follows. Specification of multiple values or multiple keywords is supported through the use of
comma delimitation.
MINUTE
valid range of 0 through 59. Default is 0.
HOUR
valid range of 0 through 23. Default is 0.
WEEKDAY
acceptable values are SUN, MON, TUE, WED, THU, FRI, SAT.
DAY
valid range of 1 through 31. A day which is specified as greater than
the number of days in the month denotes the last day of the month.
Default is every day of a month.
MONTH
valid range of 1 through 12. Default is every month.
The EVERY and INTERVAL qualifiers are mutually exclusive. When a DAY is specified that exceeds
the actual number of days in the month, ActiveBatch will assume that the last day of the month is to be
selected. If multiple DAYs are specified which exceed the actual number of days in the month, the job
will be scheduled once on the last day of the month.
/FAILURESTART=(job-id,…)
This qualifier indicates one or more jobs to trigger if the job completes in failure. One or more job-id’s
are entered in a comma delimited format.
/GRANT=(account:access,…)
This qualifier is used to associate security permissions to the job that is to be created. To associate
permissions for this job, you may specify one or more accounts and the level of access each account
(or group) may have. Access is specified using one or more of the following keywords:
READ
Read access
WRITE
Read and Write access
DELETE
Delete access
TAKEOWNERSHIP Take Ownership
TRIGGER
Trigger access
TRIGGERQUEUE Trigger with Queue change access
TRIGGERPARAM Trigger with Parameters change
303