Download User Manual

Transcript
Chapter 2 - Channel Types
Pressing aux to fader assigns control of all input channel’s auxiliary sends to the channel faders.
Pressing aux to rotary assigns control of all input channel’s auxiliary sends to the top available encoder row beneath the Channel Strip
panel.
The purple copy levels from buttons also affect the sends to that aux bus from all of the Input channels. The buttons list can be scrolled
using the scroll bar on the right. These buttons are used for universally setting the aux send levels: Off sets the level to off and 0dB to
0db. fader sets each Input channel’s aux send level to match the level of its channel fader. The remaining copy levels from buttons copy
a different set of Input channel aux send levels to that aux send.
Note that when a copy levels from button has been pressed, send levels can still be individually readjusted within the
Input channel.
2.7 Matrix Channels Specific Functions
As the Matrix channel input signals are defined within the Matrix inputs display, there is no input selection available within the Matrix
channel.
2.8 Channel Signal Processing
Each channel type contains the same signal processing functions. These include high-pass and low-pass filters, a four-band EQ and a
compressor/gate. Pressing on each of these areas of the channel strip will open the relevant signal-processing display.
2.8.1 Channel Filters .....................................................................
The filters section of the channel-strip is located below the input section. It consists of two frequency pots, each with its own on/off button
and a display of the filter’s cutoff frequency in Hertz. The on/off buttons are grey to indicate that the frequency band is off, and red to
indicate that it is on. The low-pass filter is at the top and the high-pass filter is at the bottom, and both have a roll-off of 24dB per octave.
The filters directly follow the input section in the signal chain.
The filters area is replicated at the top of the EQ/filters display, accessed by touching the EQ area of the channel strip. The filter can be
configured using the dedicated filter encoders and buttons at the top of the channel worksurface controls:
A graphic representation of the filters is included in the EQ graph located below Insert A in the channel strip, described below. The red
line in the graph represents the current filter settings.
1-12