Download 820 User Manual

Transcript
P9cr
S177,1cr
S178,1cr
S192,1cr
P100cr
(1) sets all report enables in setup to [No]
(2) sets the Data report, Run-log, and EXCD report
enables (short) to [Yes] and
(3) begins printing to the computer
Syntax
Description
P0
Standard Report (Formatted from normal setup parameters)
P1
Data Report
P2
Data & Histograms
P3
Short Full Report (Histories with SHORT option)
P4
Long Full Report (Histories with LONG option)
P9
All Report Enables Turned OFF
P 100
Begin Printing a Report
P 101
Begin Printing using RXD as Hardware Handshake flow control
P 999
Abort Printing
X 100
XMODEM Begin Printing (same as P100 except through the XMODEM communication protocol)
^X^X
CANcel transfer mode, 2 in a row (ASCII <CAN> or CHR$(24))
Error Messages and Warnings
The code listed is the number provided by R98.
All error messages begin with: CHR$(7), “ERROR - ”
Error Code
Message
1
“COUNT OVERFLOW”
2
“EXPONENTIAL OVERFLOW”
3
“RTX TASK SELECT”
4
“ILLEGAL EXCHANGE RATE”
5
“UNKNOWN INTERRUPT”
6
“WATCHDOG RESET”
7
“OPCODE ERROR”
All warning messages begin with: CHR$(7), “WARNING - “
9/26/97
B-31