Download SMASH - Reference manual
Transcript
Chapter 9 - Directives ___________________________________________________________________________________ Sweeping the value of a parameter .PARAMSWEEP Syntax .PARAMSWEEP param_name start stop [DEC|LIN] step|n or .PARAMSWEEP param_name LIST value_1 value_2 ... value_n Note: .STEP is allowed instead of .PARAMSWEEP Parameters description Name Default Description param_name start stop step|n - Name of .PARAM parameter Initial value for sweeping Final value for sweeping step: step value for linear sweeping n: number of points per decade for log. sweeping value_1 value_2 value_n - value for the first run value for the second run value for the nth run Note: please read the .PARAM directive description before you read the text below. This directive is not a specific analysis specification by itself. It is used to run a series of simulations while varying a parameter. This feature works for transient, DC transfer, noise, math and small-signal analysis. The parametric analyses are launched from the Analysis menu, with the “Transient > Sweep”, “Small signal > Sweep”, “Noise > Sweep” and “DC transfer > Sweep” items. The results of the runs are displayed in the same window, so that you can see the impact of the parameter variation upon the output waveforms. Each simulation uses the same control parameters as in the case of a single run. Three kinds of sweeping are available: linear sweeping, logarithmic sweeping, and list sweeping. In case of a linear sweeping (LIN keyword given, or no keyword given) the value of the parameter is swept from start to stop using step step. In case of a logarithmic sweeping (DEC keyword given), the value of the parameter is swept from start to stop using n points per decade. In case of a list sweeping (LIST keyword given), the parameter sequentially takes the specified values. The presence of a valid .PARAMSWEEP directive in the pattern file makes the Sweep entries in the Analysis menus active, otherwise, these are greyed. Note: a single .PARAMSWEEP directive is allowed, ie you can not cumulate .PARAMSWEEP directives. As for MonteCarlo analysis, the swept parameter can be any parameter defined with a .PARAM directive. The normal value (the one defined by the .PARAM directive) of the parameter is overriden with the value of the current sweep run. Previous versions of SMASH™ allowed 261