Download Untitled

Transcript
Appendix B
gateway
bigpipe gateway failsafe arm | disarm | show
Description
Turns the gateway fail-safe feature on and off. This command is
supported only for redundant systems.
The typical use of gateway fail-safe is where active and standby
BIG/ip Controllers use different routers as gateways to the internet.
Fail-over is triggered if the gateway for the active controller is
unreachable. Note that this is not a condition that is reliably
detected by the interface fail-safe feature, but is reliably detected by
gateway fail-safe.
To arm fail-safe on the gateway:
bigpipe gateway failsafe arm
To disarm fail-safe on the gateway, enter the following command:
bigpipe gateway failsafe disarm
To see the current fail-safe status for the gateway, enter the
following command:
bigpipe gateway failsafe show
B - 12
F5 Networks, Inc.