Download XE166 Derivatives

Transcript
XE166 Derivatives
Peripheral Units (Vol. 2 of 2)
Universal Serial Interface Channel
19.4
Synchronous Serial Channel (SSC)
The synchronous serial channel SSC covers the data transfer function of an SPI-like
module. It can handle reception and transmission of synchronous data frames between
a device operating in master mode and at least one device in slave mode. The SSC
mode is selected by CCR.MODE = 0001B with CCFG.SSC = 1 (SSC mode is available).
This chapter contains the following sections:
•
•
•
•
•
•
Signal description (see Page 19-131)
General SSC issues (see Page 19-139)
Master mode operation (see Page 19-142)
Slave mode operation (see Page 19-149)
Protocol registers (see Page 19-151)
Timing considerations (see Page 19-157)
19.4.1
Signal Description
A synchronous SSC data transfer is characterized by a simultaneous transfer of a shift
clock signal together with the transmit and/or receive data signal(s) to determine when
the data is valid (definition of transmit and sample point).
SSC Communication Master
DOUT
TBUF
DIN
RBUF
DX0
Baud Rate
Generator
Slave Select
Generator
SCLKOUT
SELOx
SSC Communication Slave
Master Transmit /
Slave Receive
DIN
Master Receive /
Slave Transmit
DOUT
Slave Clock
Slave Select
DX0
RBUF
TBUF
SCLKIN
DX1
SELIN
DX2
fSYS
(Slave)
fSYS
(Master)
SSC_Signals_
Figure 19-31 SSC Signals for Full-Duplex Communication
In order to explicitly indicate the start and the end of a data transfer and to address more
than one slave devices individually, the SSC module supports the handling of slave
User’s Manual
USIC, V1.0
19-131
V2.1, 2008-08