Download System Units User`s Manual
Transcript
XC2000 Derivatives System Units (Vol. 1 of 2) Preliminary 6.6 System Control Unit (SCU) Global State Controller (GSC) Beside power saving modes and the clock management Mode Control for the system peripherals provides an additional opportunity for configuring the system to the application needs. Mode Control is described in detail in this chapter and is implemented by the GSC. The GSC enables the user to configure one operating mode in a fast and easy way, reacting fast and explicit to needs of an application. Feature Overview The following issues are handled by the GSC: • • • Control of peripheral clock operation Suspend control for debugging Arbitration between the different request sources According to the requests coming from the OCDS, the SWD pre-warning detection or other blocks, the GSC does an internal prioritization. The result is forwarded as broadcast command request to all peripherals. The GSC internal prioritization scheme for the implemented request sources is shown in Table 6-15. 6.6.1 GSC Control Flow At least one request source asserts its request trigger in order to request a mode change in the SoC. If several requests are pending there is an arbitration mechanism that treats this issue. Request triggers are not stored by the GSC, therefore a trigger source has to assert its trigger until the trigger is no longer valid or needed. A request trigger is kept asserted as long as either the request is still pending or the resulting command of the request was entered and acknowledged by the system. The communication of the GSC and the peripherals is based on commands. Three different commands are defined resulting in three modes: • • • Wake-up command – This command defines the Normal Mode Clock-off command – This command defines the Stop Mode Debug command – This command defines the Suspend Mode Each peripheral defines its specific behavior for these three modes via the module register mod_KSCCFG. 6.6.1.1 Request Source Arbitration The arbitration is a priority driven arbitration. The highest priority in this arbitration is zero. User’s Manual SCU, V1.1 6-156 V1.0, 2007-06
Related documents