Download Register description
Transcript
JetMove 2xx at the JetControl 15.6 Sample Program "Length Measurement" // Basic configuration of the conveyor belt axis: // The axis is set as a linear modulo axis; i.e. it is an endless axis // of the positioning unit mm. // // // Example of Modulo Setting: JM_Axis.Ax_nm_AxisType:= cn_Ax_AxisType_Lin; JM_Axis.Ax_nm_ModuloAxis := cn_Ax_ModuloAxis_Yes; JM_Axis.Ax_fm_GearRatioMotor := 4; // Gear Ratio - Motor JM_Axis.Ax_fm_GearRatioLoad := 1; // Gear Ratio - Mechanism // Linear / Rotation Ratio: // e.g. 30 mm, i.e. one revolution of the gearbox results in a linear // motion of 30 mm. JM_Axis.Ax_fm_LeadScrewPitch :=30; JM_Axis.Ax_fm_TravelPosMin := 0; // Travel Limit - Negative: JM_Axis.Ax_fm_TravelPosMax := 10000; // Travel Limit - Positive: ... // Setting up the "Position Capture" function: // Deactivate the capture function: JM_Axis.DI_nm_CapCmdClr := 0x10E; When Bit_Clear (JM_Axis.JM_nm_State, cb_State_Busy) Continue; ... Process ... // Cycle: Measure the length of the packet While True Do // Set the polarity of the digital input INPUT to 24 V = logical 1. // This means that the rising edge will trigger the Capture event. JM_Axis.DI_nm_CapEdge := 0x0100; // Activate the "Position Capture" function (R513.Bit8 = 0 is set): JM_Axis.DI_nm_CapCmdSet := 0x0100; // Wait, until the Capture event takes place: When Bit_Set(JM_Axis.DI_nm_CapStatus, 8) Continue; // Temporarily store the first capture position value in a floating// point register. CapPos := JM_Axis.DI_fm_CapPosInt; // Set the polarity of the digital input INPUT to 0 V = logical 1. // This means that the falling edge will trigger the Capture event. JM_Axis.DI_nm_CapEdge := 0x0000; // Activate the "Position Capture" function (R513.Bit8 = 0 is set): JM_Axis.DI_nm_CapCmdSet := 0x0100; // Wait, until the Capture event takes place: When Bit_Set(JM_Axis.DI_nm_CapStatus, 8) Continue; // Calculate the length: // Check for position overflow If JM_Axis.DI_fm_CapPosInt > CapPos Then // No position overflow. Length = JM_Axis.DI_fm_CapPosInt - CapPos; ELSE // Position overflow: // Calculate the difference between the positive maximum // position and the latest measuring. Overflow1 := JM_Axis.Ax_fm_TravelPosMax - REG CapPos; Jetter AG 331
Related documents
JX2-CNT1 User`s Manual
S/C-Band J Series Compact Medium Power Amplifier VZS/C
AN414 - Wireless Control Application Kit
PDF ABS Safety Manual
User manual
User manual
JetMove 215-480 User Manual
- Docket Alarm
JetMove 203-230 User Manual Edition 1.10
User manual
User Manual JetMove 1000 - Servo Amplifier