Download RGL 600 SMARTBAR
Transcript
APPENDIX A - DRIVING YOUR MACHINE USING THE SMARTBAR 1 ft There are many different driving techniques and various conditions encountered when following parallel swath lines to cover a field. No single technique or method is likely to be suitable for all conditions. The Smartbar’s guidance display gives the operator indications to help follow the swath line accurately. The operator can see both offset and angle LED indicators. 3° COG 20 feet In the diagram shown to the left, the machine is exactly on swath (i.e. no offset error), but is moving along a line which points 3o left of the swath line being followed. The Smartbar is configured with SCL set to NRM (first LED is 1 ft) and ANG set to ON (first LED is 1o). If the offset LED’s alone were used for guidance, the machine must swath line move 20 feet forward from the position shown offset LED's before an offset LED guidance indication is given. By using both the offset and angle LED’s, the angle LED's operator knows that the machine is on swath and needs to turn gradually to the right. Two angle LED’s showing on the right side indicate a 3o correction is needed to the right. Using this method, an operator can drive a very straight line that has minimal offset error from the swath line. In the diagram shown to the left, the machine is 2 feet right of the swath line and has the same angle alignment as previously. The two offset LED’s on the left are telling the operator to drive to the left. The two angle LED’s to the right are telling the operator to turn to the right. This looks like a problem. However, the operator can drive left to correct the offset error, but already knows a right turn correction will be needed very soon. 3° 2 ft swath line offset LED's angle LED's In the diagram shown to the lower left, the machine is 2 feet left of the swath line and has the same angle alignment as previously. The two offset LED’s on the right are telling the operator to drive to the right. The two angle LED’s to the right are telling the operator to turn to the right. The operator can simply drive right to correct the offset and angle alignment error. 3° 2 ft swath line offset LED's angle LED's 67