Download PowerSocket - The Media Computing Group

Transcript
63
Appendix C
Schematics of the
prototype
C.1
Schematics
In this part of the Appendix the schematic of the prototype, introduced in this work, can be seen. Figure C.1 depicts the power supply of the prototype. It is based on the
viper22a1 , which is a switching mode power supply. As
a reference board the STEVAL-ISA035V12 is used. To get
the required 3.3V a linear regulator is used, coupled on the
output of the SMPS circuit. The linear regulator used, is the
LD1117S33CTR3 . The bill of material for the design of this
power supply can be found in Table C.1.
In Figure C.2 the schematic of the analog front end of the
prototype, presented in this work, can be seen. Table C.2
shows the bill of materials used to construct this part of the
circuit.
In figure C.3 the schematic with the MCU EM773 and some
periphery around it can be seen. The EM773 microcontroller used in the schematic has a user manual4 and a
1
http://www.st.com/web/en/resource/technical/document/datasheet/CD00087939.pdf
http://www.st.com/web/en/resource/technical/document/application note/CD00159053.pdf
3
http://www.st.com/st-web-ui/static/active/en/resource/technical/document/datasheet/CD00000544.pdf
4
http://www.nxp.com/documents/user manual/UM10415.pdf
2