Download 3 - powerbridge.de

Transcript
DMA Controller
from within the Functional Exception Clear (FECL) register. An interrupt
will be generated anytime the DMA Controller changes from a busy state
to a done, paused, or aborted state.
Transfer Throttling
It is possible that the PCI or PowerPC bandwidth consumed by the DMA
Controller could swamp the system with DMA activity. This is particularly
a problem if PCI or PowerPC arbitration is in favor of the Harrier.
The PCI bus has a built-in system check on excessive bandwidth
consumption. The Master Latency Timer will be a driving factor for how
much PCI bandwidth a DMA transfer may take. In addition, the PCI Backoff Timer may be used to further control bandwidth consumption. The PCI
Back-off Timer determines how long the DMA PCI Master will wait
between starting burst transfers when a transfer is interrupted by the PCI
Master Latency Timer. This timer is controlled by the PBT field within the
DCTL register. Note that if the Master Latency Timer does not expire, then
the DMA PCI Master will attempt to complete a DMA transfer as one
continuous PCI burst in accordance with the abilities of the DMA FIFO.
Bandwidth consumption on the PowerPC bus is controlled by the transfer
characteristics of the DMA PPC Master. The DMA PPC Master will
attempt to transfer data in user programmable block sizes of 256 bytes, 512
bytes, 1024 bytes, or continuous. The DMA PPC Master relies on the
Harrier latching request arbitration protocol. A transfer will proceed with
the PowerPC bus request asserted until the programmable transfer limit is
reached. Once this limit is reached, the DMA PPC Master will remove its
request and wait for two clock periods after the completion of the last
address tenure. This short back-off time will allow other pending PowerPC
masters a chance at obtaining the bus. After the two clock period expires,
the DMA PPC Master will reassert its request if there is more data to be
transferred.
http://www.motorola.com/computer/literature
2-59
2