Download Windows
Transcript
STRAP The following are guidelines for constructing an accurate finite element model: Use quadrilateral elements: In general, try to use quadrilateral elements instead of triangular elements as they give more accurate results. Remember that the four corners of a quadrilateral element should all lie on the same plane. If this is not possible, use two triangular elements in place of each quadrilateral. Element shape: - Quadrilateral Elements: The greatest accuracy is achieved with a square - 1:1 - element. Elements with a base/height ratio up to 1:2 give good results, but elements with a ratio of 1:5 will be unreliable. Try to use rectangular shaped elements whenever possible, If not, the internal angles should not vary greatly from 90°. Angles of 30° or 150° will greatly reduce accuracy. Elements with convex angles should never be used. - Triangular Elements: Equilateral triangles will produce the most accurate results. Mesh Density: The mesh density need not be constant throughout the model. The program assumes a linear result distribution through the element. If the actual result through the elements is not linear but parabolic, for example, it is obvious that there will be a decrease in the accuracy. In a fine mesh, the result diagram through any one element will always be approximately linear. Increase the number of elements where there is a greater rate of change in the internal forces. For example, around supports (where bending moments increase sharply), openings and large concentrated loads. To decrease the number of elements: Use a rough mesh in areas where relatively low results are expected. Remember that the connection to adjacent elements is through the element end nodes only and so nodes located along an edge of an element between end nodes are ineffective. Use triangular or trapezoidal shaped elements to step between rough and fine quadrilateral meshes. If you have doubts as to the accuracy of the results in a particular area of the model, rerun the problem with a finer mesh in that area and compare results. The results converge to the exact solution as the mesh becomes more refined. Models with axes of symmetry: Large symmetric structures can be modeled by defining only one half (or a quarter) of the model. Note that the symmetry must be present in both the geometry and loading diagrams. Care must be taken to define the correct boundary restraints along the line of symmetry. An error in defining the proper restraints will lead to incorrect results. Version 12.5 1.7-3 12/06