Download HCX User Manual

Transcript
HCX User Manual Version 1.1
Date Printed: 5/30/2008
Data Output
•
•
•
•
The beeper and LED indicate configuration and operational status of the flight computer
before the flight.
The beeper and LED read out peak altitude after landing. You can configure the unit to
also beep out the maximum airspeed.
You can configure the beeper to read out in either Metric or English units.
You can program the fourth output channel to accommodate many different flight plans.
User Controls
•
•
•
•
•
•
•
•
•
You can enable either cluster or stage mode on pyro channel 1.
When you use pyro channel 1 for staging, you can operate a 1st, 2nd, or 3rd stage event.
You can configure pyro channel 2 to fire either at either inertial or barometric apogee.
You can configure pyro channel 3 activate the low-altitude event in 100 foot/meter
increments.
You can configure the low-altitude event in either Metric or English units.
You can configure pyro channel 4 to:
o Activate an event based on data from a 3.3v or 5.0v user-provided sensor.
o Activate an additional event based on data from the barometer or accelerometer.
o Turn off the same or a different event.
You can also delay activating any channel’s event. The delays are set in 0.1 second
increments in a range from 0 to 25 seconds.
You can connect your HCX to a personal computer using the G-Wiz USB or RS232
Interface Cards. The Communication Interface cards attach to the communication
interface socket. This card is the same one used for the LCX and MC2 flight computers.
Once the flight computer is connected, you can upload configurations and firmware
upgrades through your personal computer.
You can set the recording rate between 66.67 samples per second and 500 samples per
second in 6 user selectable settings. Recording bit depth is 12-bits per sample.
Data Storage
•
•
•
•
The firmware is stored in flash memory, and can be conveniently upgraded by the user
when new versions are released by G-Wiz Partners.
The flight computer records flight data on a removable Mini-SD memory card.
The Mini-SD card can record multiple flights between downloads.
The included SD card adapter allows convenient download of flight data to your personal
computer.
FlightView Software
•
•
Available for Windows, Macintosh, and Linux systems.
Use it to:
o Download flight data recorded during the flight from the Mini-SD memory card.
o Analyze and chart the recorded and calculated data from your flight
o Save the flight data to your personal computer.
Page 3