Download PART 2
Transcript
Parallel Interface Port (PIP) CICR should also be initialized.) 12. Write $0170 to SPMODE to enable normal operation (not loopback), master mode, SPI enabled, and 8-bit characters. The SPI baud rate generator speed is ignored because the SPI is in slave mode. 13. Set the STR bit in the SPCOM to enable the SPI to be ready once the master begins the transfer. NOTE If the master transmits 3 bytes and negates the SPISEL pin, the Rx BD will be closed, but the Tx BD will remain open. If the master transmits 5 or more bytes, the Tx BD will be closed after the 5th byte. If the master transmits 16 bytes and negates the SPISEL pin, the Rx BD will be closed with no errors, and no outof-buffers error will occur. If the master transmits more than 16 bytes, the Rx BD will be closed (completely full), and the out-ofbuffers error will occur after the 17th byte is received. 7.12.8 SPI Interrupt Handling The following list describes what would normally occur within an interrupt handler for the SPI. 1. Once an interrupt occurs, the SPIE should be read by the user to see which sources have caused interrupts. The SPIE bits would normally be cleared at this time. 2. Process the Tx BD to reuse it and the Rx BD to extract the data from it. To transmit another buffer, simply set the Tx BD R-bit, the Rx BD E-bit, and the STR bit in SPCOM. 3. Clear the SPI bit in the CISR. 4. Execute the RTE instruction. 7.13 PARALLEL INTERFACE PORT (PIP) The PIP is a function of the CPM that allows data to be transferred to and from the QUICC over 8 or 16 parallel data pins. The pins of the PIP are multiplexed with the 18-bit port B parallel I/O port. The PIP supports the Centronics interface and a fast parallel connection between QUICCs. When the PIP is used, the SMC2 channel is not available. 7.13.1 PIP Key Features The PIP contains the following key features: • 18 General-Purpose I/O Pins • Three Handshake Modes • Programmable Handshake Timing Attributes • Supports Centronics and Receiver/Transmitter Interface • Allows Bidirectional Centronics (P1284) Operation To Be Implemented • Supports Fast Connection Between QUICCs • Can Be Controlled by the CPU32+ Core or by the CPM RISC MOTOROLA MC68360 USER’S MANUAL 7-331