Download User`s Guide DG5000 Series Function/Arbitrary Waveform Generator
Transcript
Chapter 10 Advanced Operation RIGOL Print Users could store the screen graph into external USB flash device or print it using PictBridge printer. Press Utility Print to open print setting interface. 1. To Print Screen to PictBridge Printer Connect the PictBridge printer first. Use USB cable to connect the USB Device interface of the generator to the USB Host interface of the printer (as shown in the figure below). USB Cable DG5000 PictBridge Printer USB Host USB Device Set the Device Type to “Printer” (refer to To Set USB Device Type) and press Pict Bridge to enter the setting interface. Print: Prints the screen after 10 seconds you press the key. Copies: Specifies the required number of copies to be printed by using the knob. The maximum is 9999 copies. Palette: Selects the picture color from “Gray” or “Color”. Inverted: Enables or disables the inverse print. 2. To Store Screen to USB Flash Device Please connect a USB flash device first. When the connection succeeds, an icon will be displayed on the status bar of the screen and the corresponding prompt message will be displayed on the screen. Press U Disk, a clock icon and a countdown prompt (10 s) will appear on the left of the icon. Switching the screen to your desired image within the specified time, the generator will automatically store the image under the folder named “Rigol” (created automatically if it do not exist) in the USB flash device in bitmap form (*.BMP). If the storage operation succeeds, the screen will display corresponding prompt message. 10-22 User‟s Guide for DG5000