Download imc WAVE

Transcript
The Order Analyzer
261
•
Selection of the RPM-input
Here you can select the physical input of the measurement device to
which to connect your RPM-signal.
•
Selection of incremental encoder type
Here you can select the type of incremental encoder connected to
your device. The available types are incremental encoder, Cogwheel
(1 missing cog) and Cogwheel (2 missing cogs).
•
Cogs/Impulses
Here, you can set the number of impulses or number of cogs per
revolution. If you have selected an encoder with one or two missing
cogs, enter here the complete cog count, including the missing
ones; e.g., if the whole wheel has 60 cogs though two were
removed for synchronization purposes, enter 60 cogs.
•
Minimum
Set the minimum RPM-value here, if the encoder is not to be used
as the reference quantity for the order analysis.
•
Maximum
Set the maximum RPM-value here, if the encoder is not to be used
as the reference quantity for the order analysis.
The hardware settings for the incremental encoders are made in the
Additional Channels dialog. There, you can make the filter settings, for
instance, or set the channels' switching thresholds or hysteresis. The
encoder channel is always assumed to be an incremental encoder channel
with the setting "Impulse instant". Thus, in the list of encoders, only such
channels appear whose setting is "Impulse instant". In this setting, the
RPM-value is measured at a sampling frequency of 32MHz. This makes
highly precise measurement of angle possible.
If the encoder signal is disturbed, you can specify band limits for RPMfiltering, in order to prevent a large portion of the disturbance from
affecting the processing of the angle signals. The filtering is activated for
the encoder signal by means of the option button "Filtering active". The
available parameters are the order, the characteristic curve and the filter's
3dB cutoff order.
Reference channel
Select which reference channel you wish to carry out the order analysis
with. There are two basic options available:
1. Encoder reference quantity
The incremental encoder channel specified under Encoder is used as
the reference channel for the order analysis.
imc WAVE User's Manual
© imc Meßsysteme GmbH Berlin 2002 - 2007