Download MXview User`s Guide

Transcript
MXview
Device Discovery and Polling
Deleting a scan network will remove the monitored devices that belong to the network. Take the following steps
to delete a scan network:
1. Select Project  Scan Range
2. Select a row in the table Scan Range
3. Click Delete Network
4. Click OK to activate the change
Modifying a scan network will remove devices that do not belong to the new network, and discover new devices
within the new network. Take the following steps to modify a scan network:
1. Select Project  Scan Range
2. Select a row in the table Scan Range
3. Click Modify Network
4. Modify the starting and ending IP address of the range, and then click OK
5. Click OK to activate the change.
Deselecting the Active checkbox of a scanned network will stop device discovery for that network. Previously
discovered devices will continue to be monitored, with the current status shown on the topology map.
Device Discovery
MXview will use SNMP and ICMP to discover devices within the scan ranges. When a Moxa device has been
located, MXview will use an actual image of the device, such as the one shown below, to indicate the device’s
location in the network.
MXview will also list detailed properties and configuration parameters, including the following:
•
MAC address
•
Model name
•
IP address
•
Netmask
•
Gateway
•
Trap server address
•
Auto IP configuration
•
Type of redundancy protocol
•
Role in redundancy protocol
•
Status and properties of the port
•
Status of the power
•
Status and version of the SNMP protocol
7-3