Download Creatr - Leapfrog

Transcript
Creatr
45
Enabled: here the user can activate the generation of a roof on top of the support structure to
make an easy removable interface between part and support.
Gap: here the user can set the size of the gap between roof and part define as a multiple of
the layer thickness.
Number of layers: here the user can set the number of layers that will generated to construct
the roof.
Line distance: here the user can set the distance between 2 lines of the line infill used to
generate the roof structure.
Z-offset: here the user can set an additional offset on the layer height used to print the roof
structure.
Print speed factor: here the user can set the speed at which the support structure will be
processed as a % of the nominal speed defined in the material profile.
Extrusion factor: here the user can set the amount of extrusion that will be used for the
support structure as a % of the master extrusion rate defined in material profile.
Raft
Enabled: here the user can activate the generation of a raft structure.
www.materialise.com
Materialise – Technologielaan 15 – 3001 Leuven – Belgium