Download WI-FI Final Report - Electrical and Computer Engineering

Transcript
Hosting Multiple Remotes
It is possible to host multiple remote units from the same host computer. Using the Host’s Remote
Management Application, you can easily choose the remote unit you want to host from the dropdown list. Note that you can only host one remote at a time.
Using the System
Dictation
To use the dictation feature, simply press the “Rec” button once on the unit. When the Record
indicator light stops flashing and stays on steady, the system is ready to receive audio data and
transmit it to the host computer for processing. To stop recording, press the stop button on the
remote. On the host computer, you should be able to see the effects of your recording, either in
the voice recognition program, or in the audio application you are using, depending upon your
situation.
By pressing record, you started recording a new audio track, and by pressing stop, you signal the
end of the track. The number of tracks you can record and store at a time is controlled by the
Host’s Remote Management Application. The default number of tracks is set to ten, but this
number can be changed easily by opening the settings in the Remote Management Application.
The only limit on the size of audio data that can be stored is the size of your free hard disk space.
Please note that the size of tracks you record increases with the amount of time stored in the track.
If your host computer is out of hard disk space to take dictation, you may be unable to record new
audio data or translate voice into text. In this case, you will need to clear some disk space. Refer
to your computer’s help system for information on freeing some disk space.
Playback
To playback what you recorded, simply press the “Play” button once on the remote. You should
hear the audio you just recorded play back over the speaker on the remote unit. In the case of a
voice recognition program, you should hear the voice recognition program reading back the text
you spoke into the remote.
If you have not yet recorded audio with the remote unit, you will not be able to playback any
audio. This is also the case if you restarted your computer or closed the audio or voice recognition
program you were using to record audio data.
The playback feature always plays back the last track you recorded, unless you have used the track
skipping buttons to navigate among tracks you recorded. Note that if you record another track
after skipping among the tracks, the playback feature will again play back the last track you
recorded.
Skipping Tracks
To skip between tracks you have recorded, press the “Next” or “Prev” buttons on the remote unit.
Each press will skip one track in the specified direction. If you have not recorded any tracks, then
the skip buttons will not have any effect on the system.
The track skipping buttons work in a circular fashion. For example, if you recorded five tracks of
audio data, and you try to skip backward past the first track in the list, you will effectively return
to the top of the list and hear track five again. If you try to skip forward beyond the number of
tracks you have recorded, you will arrive back at the first track in the list.
Troubleshooting
If you have problems with the system, try to troubleshoot the problems with the following table. Steps you
take here will make it much easier to fix the system if you have to call Support for help
5