Download User Manual - ECROS Technology

Transcript
are likely to happen to me first, I have not tied up the slack in the cable (but please do this
yourself). Not once have I kicked the adapter or the cable while driving or getting into or
out of the car.
Note for Mark I owners (skip this sidebar if you have a Mark II): The Mark I Mini-Scanner serial
cable cannot be attached and detached from the main unit without opening the case. If you want to
log data to a computer in the car, it may be a good idea to install the serial cable alongside the DLC
adapter cable now. It can be concealed behind the dash in the same way.
Threading the DB9 connector through the gap above the lowered steering wheel is made more
difficult by its larger size, but easier by its weight, which makes it find its way down more readily. I
accomplished this on the right hand side of the steering wheel in just a few minutes. You may have
to get creative if you have trouble, perhaps threading something else through and pulling the smaller
ten-pin connector on the other end in an upward direction. Once the cable is threaded, you can route
it where you want, for example over to the passenger side. Be very careful to tie it up so it cannot
snag on the driver's feet.
Instructions for connecting the Mark I serial cable to the Mini-Scanner main unit are published
separately.
Installing the Main Unit
Now we move our attention back to the top end of the adapter cable. We left this sticking
out behind the steering wheel and we will now attach it to the main unit.
To open the main unit case, take out the
four screws in the back with a small (#1)
Phillips screwdriver. Lift off the front of
the case by gently pulling it straight away
from the back and set it to one side. The
back part contains the Mini-Scanner
circuitry, which will look like Photo 8.
While the front is off, be careful not to
damage the exposed components inside.
Peel the protective plastic sheet from the
front of the display.
Photo 8 – The Main Unit with the Front Off
Hold the main unit horizontally with the buttons facing up. Locate the header to which
the adapter cable must be connected. It is near the lower right corner, just below the
telephone-type jack. Like the header on the DLC adapter, it consists of a group of ten
gold pins in two rows of five with one pin snipped off.
Move the main unit into position behind the steering wheel
where the adapter cable sticks out. Place the connector on the
end of the cable over the header and push it home. Make sure
that all pins go into holes in the connector. With pin 1 snipped
and its hole plugged, you can't get the connector backwards,
but it is possible to to get the top row of pins in the bottom row
of holes. Take a look from the side to make sure you've not
done this. Photo 9 shows a correctly fitted cable. Note the gap
between the connector and the telephone-type jack. If this gap
is absent, remove the connector and try again. The Pruis MiniScanner Welcome CD-ROM contains a larger photograph of
the correctly fitted adapter cable and two views of an
Page 6
Photo 9 – Adapter Cable