Download User Manual - CableOrganizer.com
Transcript
5.2. Electromechanical Meter Electromechanical meters have dials on the face and a spinning disk with a black mark. The faster the disk spins, the higher your electricity consumption. 5.2.1. Preparing Your Sensor Unit Proceed as follows to prepare your Sensor Unit for mounting on your electromechanical meter. 1. Pull the Sensor Arm latch upward to open it. 2. Extend the Sensor Arm to its full length by pulling on it. If you accidentally pull it out completely, push it back into the casing. 3. Close the latch. 5.2.2. Installing Your Sensor Unit 1. Adjust the sensor mounting strap by turning the adjustment screw several turns with a flat head screwdriver until it is a little wider than the diameter of your meter dome. 2. Fit the Sensor Unit over your utility meter as shown below. Ensure that the Sensor Arm is as close to the front of the utility meter glass dome as possible. 3. Tighten the sensor strap adjustment screw until snug. The Sensor Unit should still be able to move so adjustments can be made. Do not over-tighten! 10