Download ident

Transcript
Theory
Using the Standard or Factorization method the spectral distances calculated by
the cluster analysis differ from those calculated by the identity test. Overlapping
frequency ranges will not be merged when using cluster analysis. An artificial
spectrum is derived from the selected spectral ranges of the measured spectrum.
The artificial spectrum is used for the calculation of the spectral distances (and
the data preprocessing) and includes numerous data points of the overlapping
frequency regions.
The Scaling to 1st Range and Normalize to Reprolevel algorithms separately
calculate the spectral distances for each frequency range. Then, an average
value is calculated, and each frequency range can be weighted differently. If
you use Normalize to Reprolevel, you can additionally specify a reproduction
level for each frequency range. This level can be determined by the Make
Histogram function.
The calculated spectrum-to-spectrum distances of the cluster analysis are equal
to those calculated by the identity test if you use the Normalize to Reprolevel
method. This, however, does not apply to Scaling to 1st Range. The identity test
uses the spectral distances between the test spectrum and n reference spectra to
determine extrema. This means that n distance values have to be taken into
account per each frequency range. The cluster analysis, however, uses the
distances between all reference spectra to determine extrema. These are
( n ⋅ ( n – 1 ) ) ⁄ 2 distances for n reference spectra as the spectral distance of a
reference spectrum to itself is not considered.
To be able to compare the results achieved by the identity test and cluster
analysis using the Normalize to Reprolevel and Scaling to 1st Range methods,
the parameters required for the identity test and cluster analysis must be
identical (same reference spectra, same frequency ranges etc.). Then, start the
identity test. Use the first or last reference spectrum as test spectrum. Compare
the Hit Qualities of this IDENT test report with the spectrum-to-spectrum
distances of the cluster analysis.
4.1.2
Cluster Algorithms
There are 7 methods available to calculate spectral distances between a newlycreated cluster and all the other spectra or clusters. The algorithms most
frequently used are Average Linkage and Ward’s Algorithm.
Single Linkage
The p and q clusters are merged to the new r cluster. D(p,i) is the spectral
distance between the p and i clusters, while D(q,i) is the spectral distance
between the q and i clusters. The D(r,i) distance between the new r cluster and
the i cluster is the smaller one of the two original distances:
D ( r, i ) = min [ D ( p, i ), D ( q, i ) ]
(4-1)
This method can be used to create large clusters.
Bruker Optik GmbH
OPUS/IDENT
29