Download Intermountain Proposal

Transcript
SYSTEMDESCRIPTION
MODESOFOPERATION
ATMS.now operates in a distributed mode, making use of the intelligence in the Actuated
Signal Controllers. ATMS.now uploads and downloads to the controller all the parameters
required to operate the local intersection including time-of-day/day-of-week (TOD/DOW)
schedules. The system also monitors all intersection controllers on a real-time basis
communicating at a rate of 10,000 Kbps. Upon system startup, ATMS.now is configured to
establish communications with all intersection controllers and begin real-time monitoring.
ATMS.now is designed for unattended operation twenty-four (24) hours per day, seven (7)
days a week, without requiring an operator to be logged into the system.
ATMS.now provides system control by coordinating intersection operation on an individual,
Flex Group, or system-wide basis. ATMS.now includes the following defined control modes,
which are operator-selectable from the Graphical User Interface (GUI): Local TBC
(TOD/DOW), Special Event, Remote (Manual), System (Traffic-Responsive), Off-Line
(Standby), and Flash.
The Active Pattern drives the operation of the local signal controller. NTCIP defines
Opmodes, Src as the source of the Active Pattern. The source of the active pattern may be
Remote, System, or TBC. If the system is in standby mode then the active pattern is set to
TBC generated by the local Time of Day schedule.
In the event that, while in software-commanded override, a controller does not receive a valid
timing plan number from the central signal system software within an operator-defined time
frame, ATMS.now reverts back to its local TOD/DOW schedule.
In the event of a failure other than power failure or the severing of communications between
ATMS.now and the controller manual programming overrides all modes.
Stand‐By
ATMS.now has a Controllers Offline function that allows the user to limit the
communication of information to only those devices that are actually online and
communicating to the central server. By designating controllers that are offline, you can
isolate the controllers that are not ready for communication from the controllers that are
operational and need to communicate to ATMS.now. Both the List View in the GUI and
the Icon in the GIS show the deactivation by disabling color-coded controller conditions. It
is possible to manually schedule controllers on an intersection basis or Flex Group basis.
The whole ATMS or specific functions can be set to “View” privileges only, limiting
command and editing capabilities on a function-by-function basis.
FlashAndFree/Flash
In the flash mode, the controller does not provide green time to any movements at the
intersection. FLASH is defined as Pattern 255 by NTCIP. Flash can be initiated from the
central by either manual control or through the scheduler.
In the free mode the controller runs uncoordinated. FREE is defined by Pattern 254 by
NTCIP. FREE mode can be initiated from the central by either manual control or through
the scheduler.
City of Billings W.O. 13-09
Intermountain Traffic, LLC Response
May 15, 2013
16
Proprietary & Confidential
Do NOT Copy or Distribute